(Administrator Users Only.)
In this scenario you want to replace a freezer with a new one and re-use the Transmitter-Sensor from the old freezer in the new freezer.
| Note: | The 'old' data from the Transmitter-Sensor in its original location is kept. |
There is nothing to do in Notion Lite here. In the case of a Transmitter-Sensor with a door switch channel you just need to follow those steps Add a new Transmitter-Sensor which are concerned with setting up door switch operation.
The data gathered by the Transmitter-Sensor in its old and new locations will appear in the same Report (click 
). If you wish to separate out the data from the old and new fridges then carry out the following procedure:
1.Select Swap Out for the Transmitter-Sensor.
2.Click Swap Out to remove the association between the Transmitter-Sensor and its 'old' data.
3.Click Add Transmitter to add the Transmitter-Sensor as a 'new' device with the same Product ID but a different name.
The Transmitter-Sensor with its original name will still appear in the Transmitter Configuration table and can be reported on.